![]() ![]() This is best done while the tire is still on the ground to prevent the entire assembly from ![]() To install the new wheel hub you must first remove the old hub from the vehicle. If doing the inner tie rod be sure to tighten it back up to 66 ft-lbs.įord Escape Outer Tie Rod Nut Torque Spec : 35 ft-lbsįord Escape Inner Tie Rod Torque Spec : 66 ft-lbs Ford Escape Tie Rod Locking Nuts Torque Spec : 20 ft-lbs Once you get the nut back in place you can torque it to 35 ft-lbs. Once the outer tie rod is off you can now install the new part and reinstall it the same way it had been If you want to replace just the outer portion of the tie rod you can remove the clamp bolts further down the tie rod and remove the outer portion of the rod and replace. Once removed you can now tap out the tie rod from the spindle and You may also use a wire brush to clean off the threads prior to removal and or use penatrating oil toĪid in removal of the nut. I suggest using a pair of vice grips to hold the portion of the bolt to prevent it from The outer part of the tie rod uses a nut that will need to be removed, this nut may spin with the rest of the tie rod depending on how Once the tire is off you can now access the old tie rod and remove it for replacement. Once the vehicle is in the air you can remove the corresponding tire for the side that you want to change the This can beĭone by raising the vehicle up by either the use of a floor jack or a vehicle hoist. To install a new tie rod on a Ford Escape you must first remove the old one from the vehicle. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |